EasyManua.ls Logo

Pulse 220 - Installation; Pulse Fitness Machine Package; Location

Default Icon
13 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation Procedure
Once your Pulse Fitness equipment has been sited you must ensure that it is stable. If
necessary, adjust the height of the feet to compensate for any unevenness in the floor.
Turn the feet to the left or right to increase or decrease the height as appropriate. (See
diagram) When satisfied, securely fasten the locknut up against the Feet Strut and
place the Rubber Anti-Slip Pads underneath the feet.
To protect the paintwork from sweat, wipe down the metal frame with a wax/silicone-
based polish.
Pulse Fitness Machine Package
Before commencing installation, check that all parts and accessories have been supplied. The complete package
should include the following:
1 - Pulse Fitness Machine
2 - Integral mains cable with moulded plug fitted. (F-T Models)
UK - 13A
Euro - Schuko CEE7
USA - 5-15p 15A
3 - Technical manual (This document)
4 - Assembly user manual
5 - Console user manual
Contact your supplier immediately if any of these components are missing.
Location
Select a suitable location for your fitness equipment before moving it. The site you choose should meet the following requirements:
! A flat, level and clean surface.
! Close to a suitable mains socket. (F-T Models)
! Well away from sources of water (or other liquids) or in an area that is subject to
Condensation.
! Away from direct sunlight (this can make it difficult to view the TFT screen).
NOTE: Your Pulse Fitness equipment is not suitable for outdoor use.
Once the location has been chosen, your Pulse fitness equipment can be
Situated in the desired location. If the chosen surface is carpet then
your equipment can be pushed to the desired position.
Installation
This equipment is heavy! We do not recommended
attempting to lift it without assistance, at least 4 people
should lift any Pulse Fitness equipment when neccesary.
NEVER attempt to lift any of the equipment by the control
panel or the plastic rear panels.
When installing or adjusting any piece of Pulse
Fitness equipment, DO NOT leave any adjustment
devices projecting which could cause injury to any
third party.
WARNING
Anti-Slip Pad
Locknut
F-ST Range Feet Adjustment
260 F-T Treadmill Feet Adjustment
Locknut
06
05
Technical manual
Technical manual