Need help?Do you have a question about the Pulse XE and is the answer not in the manual?
General| Filament Diameter | 1.75 mm |
|---|---|
| Frame Material | Aluminum |
| Connectivity | USB, SD Card |
| Heated Bed | Yes |
| Nozzle Temperature | up to 300°C |
| Bed Temperature | up to 110°C |
| Nozzle Diameter | 0.4 mm |
| Supported Materials | PLA, ABS, PETG, Nylon, Carbon Fiber |
| Power Requirements | 50/60 Hz |
To Next Page