STEP 9
DETECT PRINTER
Once the correct model has been selected, the Setup Wizard Detect
Screen should be visible. (A)
Ensure that your Pulse is powered on and the USB cable is NOT
connected to your computer. Select "Continue".
If you have your USB cable connected during this step, MatterControl
will not be able to auto-detect the printer and you will need to go
through the process again.
STEP 10
CONNECT PRINTER
Connect the USB cable to computer and click "Connect". (B)
You should get confirmation of connection, and MatterControl will
prompt you to begin the initial calibration. Click "Next" to go
through the Probe Calibration wizard. (C)
To Next Page
Loading...