Punkt MP 02 - EU Compliance Statement; Fcc Compliance Statement

This device meets the government’s requirements for exposure to radio waves. This device is designed
and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by
the Federal Communications Commission of the U.S. Government.
The maximum recorded SAR values are:
Maximum SAR value
Frequency Bands used when Maximum SAR
value was recorded
When held against the head
When operated at a separation
distance of 1 cm from the body
Tests for SAR are conducted using standard operating positions accepted by the FCC with the phone
transmitting at its highest certified power level in all tested frequency bands. Although the SAR is
determined at the highest certified power 20 level, the actual SAR level of the phone while operating can
be well below the maximum value. This is because the phone is designed to operate at multiple power
levels, to only use the power required to reach the network. In general, the closer you are to a wireless
base station antenna, the lower the power output.
Body-worn measurements differ among phone models, depending upon available enhancements and FCC
requirements. While there may be differences between the SAR levels of various phones and at various
positions, they all meet the government requirement.
The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated
as in compliance with the FCC RF exposure guidelines. SAR information on this device is on file with the
FCC and can be found under the Display Grant section of http://www. fcc.gov/oet/fccid after searching on
FCC ID: XXXXXX.
For body worn operation, this device has been tested and meets the FCC RF exposure guidelines for use
with an accessory that contains no metal and that positions the handset a minimum of 1.5 cm from the
body. Use of other enhancements may not ensure compliance with FCC RF exposure guidelines. If you
do not use a body-worn accessory and are not holding the device at your ear, position the device a
minimum of 1.5 cm from your body when the device is switched on.
Important User Information
 Differences in build version mean some device models have more than one value.
 The SAR value given is the latest available information for the device model you select.
Manufacturing variations mean that the value may have changed since your device was built.
EU compliance statement
Hereby, Punkt Tronics AG declares that the device MP 02 is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
www.punkt.ch/en/products/mp02-mobile-phone/
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.