2
Unclip the aerial from the clip on the rear of the radio and fully extend it (steps A and B).
Your power adapter may be supplied with a two-pin European plug. Customers in the UK
should remove and replace with the supplied three-pin UK plug.
Insert the jack of the supplied mains adapter into the socket on the rear of the radio (C).
Plug the mains adapter into the mains supply (step D) and press the Standby button.
a) When you see the message ‘Enable energy saving?’ push the Tune dial.
b) Select ‘On’ to switch on energy saving mode (push the Tune dial).
When energy saving mode is switched on, the radio uses less power because it
does not collect and store Intellitext messages in standby. It still collects and stores
Intellitext messages while the radio is switched on.
With energy saving mode switched on, the power consumption of EVOKE Mio in standby
is less than 1 Watt.
For more information: Intellitext > page 9 energy saving mode > page 13
Wait for EVOKE Mio to complete an Autotune for all available DAB stations (this takes
about a minute). When the Autotune is complete, a station will be selected.
Start
Quick set up
Start
B
A
Stereo Out
Aux In
6V DC
D
Stereo Out
Aux In
6V DC
6V DC
C
EcoPlus
saving?
Enable energy
Energy saving
On
Tune
Tune
EVOKE Mio
Now tuning...
1
Talking to the people wh
BBC Radio 2
Quick set up > Controls at a glance > Rear connectors
To Next Page
Loading...
