PURE Electric Vehicle
PuR Energy Pvt Ltd |7
Driving your PURE EPluto:
• Take EPluto off the side stand.
• Check for the recommended tyre pressure (30-35 psi) for smooth running.
• Sit on the EPluto and ensure the battery is charged.
• Turn on the Ignition key (Clockwise).
• Press the parking button on the right hand side (with “P” symbol).
• Slowly twist the throttle to get the EPluto moving.
• It is mandatory to use a safety helmet to ensure a safe ride.
• The vehicle should not be overloaded by putting on more load than recommended.
Do’s and Don’ts while riding:
• The power to the motor cuts when brakes are applied. Do not hold on to the brakes when you want
the EPluto to run.
• It is strongly advised to not apply sudden brakes on wet, sandy surfaces.
• Avoid sudden short braking for both self-safety as well as health of the brake lines.
• While going down a steep slope, do not accelerate.
• It is advisable to use both the brakes for smooth braking and better balancing.
• Although the motor is water resistant, it is advisable to avoid driving in waterlogged areas, especially
in exposure to electricity and electric components to avoid short-circuiting.
• Avoid frequent driving of the vehicle at very low battery condition.
To Next Page
Loading...
