PURE Electric Vehicle
PuR Energy Pvt Ltd |9
2 PURE Lithium Battery
PURE EPluto, with PURE Li-ion in-house battery
manufacturing and testing, is equipped with Active Battery
Management System (BMS), which protects the battery
from damages due to short-circuiting, over-charging, deep
discharging and high temperatures.
Critical
Users should adhere to the below
safety precautions for the proper
functioning of the battery and avoiding any personal injury. Failure to comply with the
safety instructions can damage the inbuilt safety features and may lead the battery pack
to leak acid, overheat, emit smoke, burst and/or ignite.
• Do not disassemble or modify the battery pack.
• Do not connect the positive (+) and negative (–) terminals with a metal object such as a wire.
• Do not discard the battery pack into fire or heat it.
• Do not use or leave the battery pack near a heat source such as a fire or a heater (60°C or higher).
• Do not immerse the battery pack in water or seawater, and do not allow it to get wet.
• Do not recharge the battery pack near fire or in extremely hot weather.
• To recharge the battery pack, use the battery charger specifically designed for the purpose and
observe the recharging conditions specified by PURE EV.
• Do not pierce the battery pack with a nail or other sharp objects, strike it with a hammer, or step on it
• Do not strike or throw the battery pack.
• Do not use an apparently damaged or deformed battery pack.
To Next Page
Loading...
