Care should be taken when cleaning in the area of the evaporator and
condenser – it is recommended that protective gloves be worn as the
evaporator and condenser fins have sharp edges.
Do not use high-pressure water hoses.
Do not use abrasive and/or solvent cleaners that could scratch or irreversibly
damage the surface finish.
Never use a cleaning or sanitizing solution that has an oil base (these will
dissolve the butyl sealant) or an ammonia base (this will corrode the copper
components of the case)
Do not introduce water faster than waste outlet can drain/ evaporate
Do not use abrasive and/or solvent cleaners that could scratch or irreversibly
damage the surface finish.
Never use hot water on cold glass surfaces as it may shatter and cause serious
injury. Allow all glass surfaces to warm first.
Pure Cold Impact 6 Installation,
Operation & Maintenance Manual
To Next Page
Loading...