33
FAQs
Will Pureit Advanced remove salt and oil?
Input water may contain many materials which affect the taste
of water. Of these, Pureit Advanced removes materials like
oil, sand, soil, clay, dirt, decayed animal and plant waste, and
harmful pesticide impurities and is therefore likely to improve
the taste of water. However, Pureit Advanced does not
remove some dissolved salts that may contribute to taste like
sodium chloride salt, calcium and magnesium.
In fact, Pureit Advanced retains some ‘good’ dissolved salts
present in drinking water. This may affect the taste of water.
Can one pour brackish water into Pureit Advanced?
Yes, the water will be free of harmful germs, but there may
not always be an improvement in taste. However by pouring
brackish/sea water into the Pureit Advanced, there may
be a risk of choking the system, and the ‘Auto Shut-Off™’
mechanism may malfunction.
Can there sometimes be particles in the water stored
in the Transparent Chamber?
No. Particles will not escape into the Transparent Chamber
through the ltering media. However you have to drain the
rst cycle that gets collected in the Transparent Chamber.
Sometimes there is a chlorine like smell near the
Germkill Processor™. Is this a problem?
No, this is not a problem. You will continue to get absolutely
safe, odour free, great tasting water from the Transparent
Chamber.
Water is overowing from the front of the purier?
There might be two reasons for this. One, check your
Germkill Life Indicator™. If it is red, then please order for
a new Germkill Kit™ and replace it. Do not pour any more
water in the Top Chamber to avoid further spillage. Two, if
the Germkill Indicator is not red, please clean the Carbon
Polisher™ and the Advanced Microber Mesh
TM
and ensure
proper placement of all parts in the Cleansing Collection
Chamber. If the problem persists, then please contact Pureit
Advanced Helpline.
How long does it take for the water to get puried?
It depends on the quality of water that is put into Pureit
Advanced. Typically 9 litres of water gets puried between
1.5-2 hrs.
Cleaning the Carbon Polisher™ and the Advanced Microber
Mesh
TM
regularly can also improve the ow rate.
Do I need to empty the water from Pureit Advanced
if I am not using the purier for a few days.
If there is stagnant water in Pureit Advanced for more than
2 days, then discard one cycle of water and start consuming
from the fresh cycle of water.
To Next Page
Loading...
Need help?
General