23
DOs
DON’Ts
Clean the top lid, the Top Chamber, the Cleansing Collection Chamber
and the tap regularly
Clean with water and then leave the components to ‘drip dry’
Clean the tap with a mild hypochlorite solution
If necessary, use a plastic brush to aid cleaning
Remove the Germkill Processor while cleaning and keep upright in a
separate dry place
Empty the water from the Cleansing Collection Chamber before removing
the Microcharged Membrane Assembly
Remove the Germkill Processor before emptying out the water from the
Cleansing Collection Chamber
The Pureit Excella guarantee of getting water that is as safe as boiled
applies only if you ensure that the Transparent Chamber of the purier
and the tap are hygienically kept, and that germs are not introduced due
to contact with hands, drying with a cloth, wash or any other means
You should only store water in Pureit Excella purier and not use other
bottles and containers, to avoid re-contamination of the water
Always use all three components of the Pureit Excella
Germkill Kit together
You should ensure that the area around and beneath the purier is kept
clean at all times
Keep all components of the Pureit Excella Germkill Kit out of reach of
children at all times
Ensure that the purier is placed on a at surface at all times, and
never tilt the Transparent Chamber to take out water
If you ever want to shift the purier, do so only after both the
Top Chamber and Cleansing Collection Chamber are empty. Otherwise the
purier may leak, and the purication process may get affected
Always rely only on the red Indicator to replace the Germkill Kit. The
Auto Shut-off is only an additional assurance of safety – in some cases,
the input water quality may prevent it from functioning
Freshly puried water should be used for drinking
Output water may continue to have ora which are harmless and pose
no health hazard to normal healthy adults and children
Always clean the Pureit Excella system only as described in the section
on cleaning
Over a period of time you may nd ne oating particles or sealing in
Transparent Chamber because of natural minerals in the source water, in
such case just clean the Transparent Chamber with puried water
Do not clean with soap or detergent, or any abrasive cleaners or tools like wire Mesh
Do not twist the Microbre Mesh while cleaning.
The Microber Mesh might change its color over a period of time.
This does not affect the performance of the Microber Mesh
Do not use any soap or detergent. Ensure that you don’t inadvertently
introduce germs into the Transparent Chamber or the tap e.g. through your
hands or by using a drying cloth. Always use puried Pureit Excella water for
doing the last rinse of the Transparent Chamber, and then let it drip-dry
Do not normally wash the Cleansing-Collection Chamber
Don’t pour boiling or hot water (more than 50˚C) into, or on the Pureit
Excella system. Similarly don’t pour freezing cold water (less than 10˚C) into,
or on the Pureit Excella system
Do not pour hot water directly from an overhead tank or any other source in
your Pureit Excella as hot water uses up the Germkill Kit faster than normal.
If required, allow the water to cool to room temperature before pouring it in
the Top Chamber. For the same reason do not keep your Pureit Excella in hot
surroundings like direct sunlight, near a stove or near a fridge
Never buy the Pureit Excella system, or a Pureit Excella Germkill Kit from an
unauthorized source. You can visit a store near you to buy a Germkill Kit or call
us at the Pureit Excella helpline to locate your nearest dealer
Don’t in any way try to open the three Pureit Excella Germkill Kit components
Never use the system once the Pureit Excella Germkill Life Indicator shows a
full red colour in the window, with no white colour visible
Don’t expose any of the components to re
Don’t drop any of the components, or the purier as a whole from a height.
This may cause the components to fracture or break, and the guarantee of
getting water that is as safe as boiled will no longer be valid
Don’t put any chemical uids in the Pureit Excella system. This is meant
strictly for drinking water only
If the Transparent Chamber is full, please do not ll water in the
Top Chamber, otherwise water will overow from the Transparent Chamber
Do not try to open the Germkill Processor
Do not pour water in purier after Germkill Life Indicator turns fully red.
This will prevent water overowing due to Auto Shut-off. This ensures no one
is accidentally hurt by slipping on the water. Also, no household item kept
near purier would get damaged by leaked water
Do not use the Germkill Kit after expiry – which is post three years from
the date of packing
Do not keep the Pureit Excella purier in direct sunlight as it may trigger
growth of algae if input water is signicantly contaminated
Do not use water not intended for drinking in Pureit Excella system e.g., from
abandoned or abused water bodies or water sources in which human, animal or
industrial wastes are disposed, or water that is excessively acidic or alkaline
Do not consume water that is stored in transparent chamber for more than 2 days
Do not remove the Batching Chamber from the Cleansing Collection Chamber.
If it gets removed accidentally, then replace the parts in proper location,
as was assembled initially for consistent performance
Do not meddle with the Microcharged Membrane else it will get damaged
and you might get unsafe water
Don’t drink water from the purier if any one of the Germkill Kit
components is not tted
Do not twist the Sediment Filter while cleaning.
If the Sediment Filter changes colour over time depending in the quality
of water, you need not replace the same as this colour doesn't affect
the Germkill capability of Pureit, instead continue using it, you may
intermittently clean
Pureit Excella has been specially designed to give you as safe as boiled water as long as the Pureit
system is used in the way as prescribed in this manual.
Listed below are the things that you must take care of:
DOs & DON’Ts
To Next Page
Loading...
