07
1
2-layer
screw tooth
2
3
4
5
Way1
If the tap your family has
is similar to this pattern
(as the above picture)
If the water outlet is internal screw thread (the
below picture 1)
1.At first combine 2-layer screw tooth with the
water separator, then screw them tight
(procedure 1,2,3).
2.Unscrew the waver of the tap (procedure 4).
3.The set of water separator equipped with the
gasket is fixed to the tap, then screw tight
(procedure 5).
According to your own habits, the handle of
the alternative switch can fasten left or right.
If the water outlet is external screw thread (as
the left picture 2), installation procedures:
unscrew the waver of the tap, then screw the
alternative switch.
If the tap your family has is
a different pattern (as the
above picture)
Procedures:
1.First place the installation
ring.
2.Select internal socket ring,
fit over the tap.
3.Use fixtures to fasten.
Lock the alternative switch.
If the water outlet is external screw thread
(as the left picture 2), installation
procedures: unscrew the waver of the tap,
then screw the alternative switch.
Way2
Water SEPARATOR
Fix the tap to
the Water SEPARATOR
Unscrew the
water of tap
Combine and screw
the waver of tap
1 2
Unscrew the
water of tap
Screw the
alternative switch
Installation
Alternative Switch
Fix the tap to
the Water SEPARATOR
To Next Page
Loading...