Need help?Do you have a question about the Purite SELECT FUSION 160 and is the answer not in the manual?
Details the power requirements, fuse types, and serial port connections for the unit.
Specifies the required quality, flow rates, and pressures for the incoming water supply.
Outlines the water quality parameters for both high purity dispense and tank storage.
Outlines the procedure to safely shut down the unit in emergency situations.
Explains the step-by-step process of water purification from feedwater to dispense.
Lists essential checks before installation, including electrical supply and water connections.
Details the hook-up procedures for mains water, drain, and overflow connections.
Guides the user through the initial setup and start-up sequence of the unit.
Provides critical steps to shut down the unit immediately in case of an emergency.
Explains how to dispense both Grade II and Grade I+ purified water.
Lists the built-in safety features and alarm messages for unit protection.
Provides a comprehensive list of error messages and their corresponding causes and actions.
Instructions for removing and installing a new pre-filter cartridge.
Step-by-step guide for replacing the Puripac PP-8 cartridge.
Detailed instructions for replacing the NCP cartridge pack.
Guide on how to install a new 0.2 µm point of use filter.
Procedures for safely replacing the UV lamp, including precautions.
Lists common symptoms, their possible causes, and recommended actions.
Provides a detailed table of alarm messages, their displays, and reasons for the alarm.
General| Type | Water Purification System |
|---|---|
| Conductivity | < 0.1 µS/cm |
| TOC | < 10 ppb |
| Bacteria | < 1 CFU/ml |
| Particle Size | 0.2 µm |
| Power Supply | 230V, 50Hz |
| Output | 160 liters/hour |
| Purity | Type 1 ultrapure water |
| Feed Water | Potable water |
| Dimensions | 600 mm |
| Particles >0.2 µm | < 1 per ml |
| Resistivity | > 18 MΩ·cm |
To Next Page