Need help?Do you have a question about the Purite SELECT FUSION Series and is the answer not in the manual?
General| Brand | Purite |
|---|---|
| Model | SELECT FUSION Series |
| Category | Laboratory Equipment |
| Language | English |
Covers power supply, fuse rating, and connection types for the unit.
Outlines requirements for incoming potable water quality and pressure.
Defines water quality parameters for Grade I+ and Grade II dispensed water.
Details the physical connection of water services to the unit.
Step-by-step guide for initial setup, including time and date setting.
Actions to take to stop the unit immediately in case of an emergency.
How to obtain purified water from the unit's dispense points.
Detailed steps for performing a loop or full clean cycle on the unit.
Configuration of water dispensing methods like hold, latched, and volume.
Describes built-in safety mechanisms and their corresponding alarm messages.
Lists potential error/alarm messages, their causes, and recommended troubleshooting steps.
Step-by-step guide for performing loop or full disinfection routines.
Instructions for changing the external pre-filter element.
Guide for removing and installing the Puripac PP-8 water filter cartridge.
Instructions for replacing the NCP media pack in the unit.
How to replace the final filter at the water dispense point.
Common symptoms, possible causes, and actions for unit malfunctions.
Lists alarm messages, their causes, and recommended troubleshooting steps.
To Next Page