4 POW(TX power) HIGH/LOW
5 SQL(Squelch level) 0-9
6 SCRM(scrambler) OFF/1-8 scrambler groups
7 LED(backlight on/off) OFF/AUTO/ON
8 BEEP（keytone） ON/OFF
9 ANI（Automatic Number
identification）
OFF/ON
10 KEYBO(keyboard lock) MANUAL/AUTO
11 TOT(time out timer) OFF-270 seconds
12 SCANS(scan mode) TO/CO/SE
13 VOICE(voice guide) OFF/CHS/ENG
14 OFFSET(offset setting) 0-42.000(VHF)0-80.000(UHF)
15 C-CDC(RX/TX CTCSS/DCS) OFF-254.1/D023-D754
16 R-CDC(RX CTCSS/DCS) OFF-254.1/D023-D754
17 T-CDC(TX CTCSS/DCS) OFF-254.1/D023-D754
18 S-D(+/- offset) 0/+/-
19 STEP(frequency step) 2.5K/5K/6.25K/10K/12.5K/25K/50K/100K
20 NW(wide/narrow band) NARROW/WIDE
21 NAME(channel name edit) OFF/ON
22 ROGER(call end tone) OFF/ON
Menu function setting
All channel scan
Hold on [F] key, and press[ 1scan ]key, ”SCAN?” will show on the screen, Then
press [ ENT] key to enter all channel scan mode, and scan starts with the
displayed channel and it will pause for 5 seconds if any signal is detected on a
channel, otherwise it will continue to scan next channel. Press any keys except
[PTT] key and [ENT] key to stop scanning and return to the previous displayed
channel.
Priority channel scan
Press [F] key, then press [1SCAN] key and turn the channel switch, then “PRI?”
will show on the screen, Then press[ENT] key to enter priority scan mode, and
scan starts with the priority channel and it will pause for 5 seconds if any signal is
detected in a channel, then it will scan other channels in turn, press any keys
except [PTT] key and [ENT] key, it will stop scanning and return to the previous
displayed channel.
Otherwise it will scan the next channel. For instance, if channel 3 is set as priority
channel, the radio will scan 3-1,3-2……in turn.
To Next Page
Loading...
