select the normal (N) or inverted (I) DCS codes. After selection, press [ENT]
key to confirm and press [VFO/MR] key to exit.
FREQUENCY DIRECTION
Under frequency mode, press [FUN]+[9SET] key to enter the menu mode,
turn the channel switch to the eighteenth item, the screen will show “S-D?”,
press [ENT] key and turn the channel switch to select “0/+/-“,(+) indicates
increasing frequency,(-) indicates reducing frequency and (0) indicates
identical frequency. After selection press [ENT] key to confirm and press
[VFO/MR] key to exit.
FREQUENCY STEP
Under frequency mode, press [FUN]+[9SET] key to enter the menu mode,
turn the channel switch to the nineteenth item, the screen will show
“STEP?”, press [ENT] key turn the channel switch to select
“2.5K/5K/6.25K/10K/12.5K/25K/50K/100K”.(VHF default is 10k,UHF
default is 12.5K). After selection press [ENT] key to confirm and press
[VFO/MR] key to exit.
WIDE/NARROW BAND
Under frequency/channel mode, press [FUN]+[9SET] key to enter the menu
mode, turn the channel switch to select the twentieth item, the screen will
show “N/W?”, press [ENT] key and turn the channel switch to select
“NARROW/WIDE”, “WIDE” means wide band, “NARROW” means
narrow band. After selection press [ENT] key to confirm and press
[VFO/MR] key to exit.
NAME OF CHANNELS
Under frequency mode, press [FUN]+[9SET] key to enter the menu mode,
turn the channel switch to the twenty-first item, the screen will show
“NAME?”, press [ENT] key and turn the channel switch o select “OFF/ON”.
“OFF” means turn off the channel name, “ON” means turn on the channel
name. After selection press [ENT] key to confirm and press [VFO/MR] key
to exit.
TALK END TONE
Under frequency/channel mode, press [FUN]+[9SET] key to enter the menu
mode, turn the channel switch to twenty-second item, the screen will show
“ROGER?”, press [ENT] key and turn the channel switch to select
“OFF/ON”, “OFF” means turn off the TALK END TONE function.
After selection press [ENT] key to confirm and press [VFO/MR] key to
exit.
To Next Page
Loading...
