PACKAGE CONTENTS
2
PART DESCRIPTION QUANTITY
A Threshold Ramp 1
A
PART DESCRIPTION QUANTITY
A Threshold Ramp 1
PACKAGE CONTENTS
2
PART DESCRIPTION QUANTITY
A Left Side Ramp Panel 1
B Right Side Ramp Panel 1
B
A
HARDWARE CONTENTS (shown actual size)
3
AA
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the
product.
• Ramps are designed for wheelchairs and electric scooters.
• Ramps are rated for a 600 pound capacity; rating is based on double axle, evenly distributed
loads.
• Although ramp is equipped with anti-slip traction tape, caution is required as some factors can
reduce slip-resistant capabilities. Such factors include, but are not limited to, degree of wear on
the shoe and flooring material; presence of foreign material such as water, oil and dirt; length of
human stride. Caution should also be taken regarding type of floor finish and possible human
error due to physical and mental conditions. Anti-slip properties apply to laboratory conditions and
require users to use caution under field conditions as outlined here.
• For your safety, a caregiver or aid should be present at all times when using any ramp.
• Proper setup is essential for safe loading and unloading.
• Make sure that the hook (top end) is pressed firmly against the step or platform before using.
• When possible, use screws provided to lock ramp in place.
• Safe lifting practices should be used when lifting product.
• The Americans with Disabilities Act recommends a 1:12 slope; for 2-foot ramp a maximum height
of step/platform not to exceed 2 inches.
• Failure to follow all warnings/instructions may result in ramp slipping off step while occupied.
WARNING
Phillips Sheet
Metal Screw
Qty. 2
HARDWARE CONTENTS (shown actual size)
3
Please read and understand this entire manual before attempting to assemble, operate or install
the product.
• Ramps are designed for wheelchairs and electric scooters.
• Ramps are rated for a 600 pound capacity; rating is based on double axle, evenly distributed
loads.
• Although ramp is equipped with anti-slip traction tape, caution is required as some factors can
reduce slip-resistant capabilities. Such factors include, but are not limited to, degree of wear on
the shoe and flooring material; presence of foreign material such as water, oil and dirt; length of
human stride. Caution should also be taken regarding type of floor finish and possible human
error due to physical and mental conditions. Anti-slip properties apply to laboratory conditions and
require users to use caution under field conditions as outlined here.
• For your safety, a caregiver or aid should be present at all times when using any ramp.
• Proper setup is essential for safe loading and unloading.
• Make sure that the hook (top end) is pressed firmly against the step or platform before using.
• When possible, use the clevis pins provided to lock ramp in place.
• Safe lifting practices should be used when lifting product.
• The Americans with Disabilities Act recommends a 1:12 slope; for 6-foot ramp a maximum height
of step/platform not to exceed 6 inches.
• Failure to follow all warnings/instructions may result in ramp slipping off step while occupied.
CAUTION
• When carrying ramp sections, always use handles and make sure hook-and-loop straps are
secure.
Clevis Pin
Qty. 2
AA
HARDWARE CONTENTS (shown actual size)
3
AA
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the
product.
• Ramps are designed for wheelchairs and electric scooters.
• Ramps are rated for a 600 pound capacity; rating is based on double axle, evenly distributed
loads.
• Although ramp is equipped with anti-slip traction tape, caution is required as some factors can
reduce slip-resistant capabilities. Such factors include, but are not limited to, degree of wear on
the shoe and flooring material; presence of foreign material such as water, oil and dirt; length of
human stride. Caution should also be taken regarding type of floor finish and possible human
error due to physical and mental conditions. Anti-slip properties apply to laboratory conditions and
require users to use caution under field conditions as outlined here.
• For your safety, a caregiver or aid should be present at all times when using any ramp.
• Proper setup is essential for safe loading and unloading.
• Make sure that the hook (top end) is pressed firmly against the step or platform before using.
• When possible, use screws provided to lock ramp in place.
• Safe lifting practices should be used when lifting product.
• The Americans with Disabilities Act recommends a 1:12 slope; for 2-foot ramp a maximum height
of step/platform not to exceed 2 inches.
• Failure to follow all warnings/instructions may result in ramp slipping off step while occupied.
WARNING
Phillips Sheet
Metal Screw
Qty. 2
2
To Next Page
Loading...