Need help?Do you have a question about the PWM EPIP20 series and is the answer not in the manual?
Connect wires in order 1-6, use 12V batteries/systems, and respect Solar/Load ratings.
Green ON for charging, Green blink for system over-voltage.
Green ON for normal, Green flashing for full, Yellow ON for low.
Red ON for output, Red flashing for over-load or short-circuit.
Check wires, reduce amps, or reset controller by disconnecting and reconnecting battery.
Low voltage disconnect/reconnect levels, digital accuracy, and 4-stage charging.
Includes short circuit, reverse polarity, high voltage limits, and lighting protection.
Tropicalization, terminal size, weight, dimensions, operating temperature, and enclosure rating.
To Next Page
General