PYLE Audio PAMP1000 - Specifications

Input Impedance, balanced (unbalanced) ............................. 20 k-Ohms
Continuous Output Power
Stereo Mode
20 Hz to 20 kHz, 8 Ohms .................................................. 60 Watts x 2
1 kHz, 4 Ohms, ................................................................. 70 Watts x 2
Maximum Power, 8 Ohms.................................................. 65 Watts x 2
Maximum Power, 4 Ohms.................................................. 80 Watts x 2
Bridged Mode
Maximum, 20 Hz to 20 kHz, 8 Ohms ......................................130 Watts
Maximum, 1 kHz, 4 Ohms, .....................................................160 Watts
THD at rated output power............................................................ 0.1%
Frequency Response +/- 3 dB.......................................10 Hz to 50 kHz
Signal to Noise Ratio A-Weighted.................................................100dB
Speaker Impedance
Stereo.................................................................................. 4-16 Ohms
Bridged................................................................................ 8-16 Ohms
Speaker Impedance...................................................... A,B (4-16 ohms)
Bridged (8-16 ohms)
Power Requirement.................................120V AC 60Hz/230V AC 50Hz
Power Fuse.............. T 4AL 250V for 110-120V and T 2AL for 220-240V
Dimensions, inches (mm) WxHxD .. 16.53 x 2.36 x 8.26 (420 x 60 x 210)
Weight, lbs (kg) ..................................................................... 9.08(4.12)
5 - Pyle Home PAMP1000 Manual
Specifications
Specifications are typical; individual units might vary.
Specifications are subject to change and improvement without notice.