Touble Shooting
(TROUBLE)
[ No power
[ No picture
[ Stopped pletu ...
[ The playback picture is poor
[
No
color
[ Distored siund
Thl
remotl
control
dOlsn'
t work
properly
"DISK
ERROR'"
is
displlY
on
thl
.crlen
Check
point
( ACTION)
Check to
ue
that the AC power cable
Is
connected propefly.
Make sura
that
the
equipment
I.
connected proper1y. Check to see that
the connected monitor
I.
turned on
Check to
•••
that
the
video
cable
Is
connected. Check to
lee
that the
monitor Is turned on.
[ Clean the disc
The
color
system
set
by this
unit
does
not match the color system
01
the monitor.
Check the
color
system
of
the
unit.
Ajust the video system by
pre.sing
the
TV
system button. (PAL,
NTSCj
Remove any obstacl
••
betwe.n
the
remote control
unit
and the remote control
s.nsor.
Op.rate
the
remote control
at
a shorter distance.
Set
the
power
button to OFF and then
blck
to
ON
lltemaUvely,
Tum
off
the
power, disconnect
the
power
plug, and
then
reconnect It.
When a
disc
is
brought
from acold
environment
to
a hot one, there may be steam
on
the face
of
the disc,
or
water will appear
on
the pickup lens. It will affect the
play.
1.
Remove the disc from the DVD player.
2.
Turn
on
the power and leave it
on
for
an
hour to vaporize the condensation.
3.
You
can operate the DVD player without any problem.
16
Caution
Please read and observe all warnings and instructions in this owner's manual
and those marked on the unit. Retain this booklet
for
future reference.
There
are
two
kinds
of
alarm
symbols
as
follows:
WARNING
The lightning flash with arrowhead symbol within
an
equilateral
triangle is intended to
alert
the user to the presence
of
"dangerous voltage"within the product's enclosure that may be
of
sufficient magnitude to constitute a risk
of
electric shock to
persons.
CAUTION
The exclamation point within an equilateral triangle is intended
to alert the user to the presence
of
important operating and
maintenance
(servicing)
instructions in the literature
accompanying the product.
WARNING
The
driver
should
never
operate these products while the vehicle is in motion!
Installation
of
all TV monitors must be out
olthe
driver's field
of
vision I
Do
not try and service these products yourself,seek only a qualified service cente
or
factory
service center.
Be
careful not to
drop
or
apply undue pressure
to
the
front
panel
of
your
video
monitor.lfthe
screen cracks due
to
misuse
yourwarrantly
will be void!
Make sure
to
keep products away from
heater
ducts
or
vents
and
out
of
direct
sunlight. Do not mount forward
of
the driver's shoulders.
Be careful not to overload your cigarette lighter plug by adding more than one
device
at
a time.
Use extra caution with any liquids
in
your car.
If
you
or
your child spill any liquid
on
these products, pull
your
vehicle
to
the roadside and trun the key
off
to
disconnect
or wipe the products with a towel. Do not operate the equipment until all liquids
have eihter evaporated
or
you have had the monitor inspected at a service
center by a
qualified Technician. Severe harm
or
death can occurl
Use only a damp cloth to clean the screen and use only purified water
on
the cloth.wring out
811
excess water prior to wiping the screen. Do not use any
cleaners
or
chemicals
to
clean the screen. In
most
cases a
dry
cloth will do!
Do
not
mount the product
where
it will
obstruct
the deployment
of
the airbag
or
in an area where
it
would
affect
the
vehicular
control. Also be careful
to
avoid
mounting the product where
it
can become hazardous during sudden stops
or
in the
event
of
an accident.
To Next Page
Loading...
