Pyle PAH1 User Manual

The Al timeter Alarm
1. Press Button A to enter the
Altimeter Al
arm Mode.
2. To set the target altitude for the
Al
arm , press and ho ld Button A until
the digit
starts to flicker.
3. Press Button B to set the digits and
then press Button A to conflrm.
4. Repeat Step 3 to set your desire
digits.
5. After setting the target al ti tude, press
Button B to activate or deactivate
the
alarm .
6.
For the Altimeter Al arm sound, it wi ll
. Beep .. Beep .. Beep for 1 minutes
and the UP i con flashing; when
the altitude come across the target
In ascending.
. Beep Beep .. Beep Beep .. Beep
Beep
for 1 minutes and the DOWN
icon fl ashing ; when the altitude
come
across the target in
descending.
7. To read the target altitude and the
al
arm setti ng, press Button A to the
mode
and then press Button A to
quit or left
it return automatically to
Norma l Mode after 30 seconds .
l1li
" I /
IRl
- OFF ~
01
I
mil
III
,n,n
m
fU fU
0 1
01
IRl nnnnm
l- -=U:",:U:,,:U=U :.......J 01
THE HYGROMETER
1. A build-in sensor measure humidity
and shows on the displ ay .
2. To ca ll the Maximum and Minimum
Memory, press Button 0 to the
mode.
3.
To reset the memory, press and
ho ld Button B. At the same time,
the memory for the barometer wi
ll
be reset al so.
The Thermometer
1. A build-in sensor measure
temperature and shows on the
di
sp l ay .
2.
To call the Maximum and Minimum
Memory, press Button 0 to the
mode.
3. To reset the memory, press and
ho ld Button B. At the same ti me ,
the memory for the barometer wi
ll
be reset al so.
...
L......! .&..:::L- ...... -..&.J 03

Pyle PAH1 Specifications

General

Stopwatch	Yes
Product color	Black, Silver