7 - Pyle Home PCM60A Manual
Specifications
Input Impedance
AUX 1/AUX 2/AUX 3...........200mV/50k-Ohm, Unbalanced
MIC 1/MIC 2/MIC 3.................1.0mV/600-Ohm, Balanced
TEL/PAGE .............................100mV/600-Ohm, Balanced
Max Output Power.......................................100 Watts x 1
THD at rated output power..................1% or less at 1 kHz
Frequency Response +/- 3 dB................. 50 Hz to 15 kHz
Signal to Noise Ratio A-Weighted
MIC..........................................................................60dB
AUX..........................................................................70dB
TEL...........................................................................60dB
Speaker Outputs........................4-Ohm, 8-Ohm, 16-Ohm,
25V, and 70V line outputs
AUX Output...................................................600-Ohm 1V
Monitor (MOH) Output............600-Ohm 1V (head phones)
and 8-Ohm 1W (speaker)
Attenuation Level (AUX 1/AUX 2/AUX 3/MIC 2/MIC 3)...40dB
Tone Controls
Treble....................................................+/- 10dB, 10 kHz
Bass......................................................+/- 10dB, 100 Hz
Power Requirement............120V AC 60Hz/230V AC 50Hz
Power Fuse......................T 2.5AL 250V for 110-120V and
T 1.2AL 250V for 220-240V
Dimensions, inches (mm) WxHxD.......16.93 x 3.46 x 10.51
(430 x 88 x 267)
Weight, lbs (kg) ...............................................14.88(6.75)
Specifications are typical; individual units might vary.
Specifications are subject to change and improvement without notice.
Your Pyle Home Amplifier is an
example of superior design and
To Previous Page
Loading...
