Pyle PDMT25 - DC Voltage Measurement Procedure; DC Current Measurement Procedure

10
4.
DC/DC VOLTAGE MEASUREMENT
1.sert the black test lead into the negative COM terminal and
the red test lead into the positive V terminal.
2. Set the function switch to the V
AC or VDC position.
3.Use the MODE button to select AC or DC Voltage
4.Connect the test leads in parallel to the circuit under test.
5.Read the voltage measurement on the LCD display
DC CURRENT MEASUREMENT
1. Insert the black test lead banana plug into the
negative (COM) jack.
2. For current measurements up to 4000uA DC, set
the function switch to the uA position and insert the
red test lead banana plug into the (uA) jack.
3. For current measurements up to 400mA DC, set the
function switch to the mA range and insert the red
test lead banana plug into the (mA) jack.
4. For current measurements up to 10A DC, set the
function switch to the A position and insert the red