Pyle PSBT125A User Manual

www.PyleUSA.com 5
Problems
No sound or faint sound
from speaker
1. Volume turned down.
2. Power switch is turned o.
1. Adjust volume
2. Turn power switch on
Power indicator not on
Distorted sound from
from speaker.
1. Volume set too high.
2. Excessive wind noise breath pops.
3. Input signal too strong.
1. Reduce volume
2. Use windscreen on wireless &
wired microphone
3. Adjust input signals.
Excessive feedback
Excessive Hum or Noise
Shortened Battery Life
Battery CHARGE Indicator
Not Flickering when
plugged into AC Outlet
Possible Cause Solution
1. Power switch is turned o.
2. Rechargeable Battery is
discharged.
3. Rechargeable battery is dead.
1. Turn power switch on.
2. Plug into AC outlet to recharge.
3. Replace battery and plug into AC
outlet to recharge.
1. Microphone too close or directly in
front of the speaker.
2. Volume set too high.
3. Microphone too far from sound
source. (requiring the volume to
be turned up to compensate)
1. Move microphone away
from the speaker.
2. Recharge.
3. Speak closer to the microphone or
move microphone closer to
sound source.
Weak, Distorted Sound
Power Indicator Flickers
1. Batteries level is low
1. Input Cable not shielded
1. Old or overused battery
2. Battery is not charged
for over 4-3 months.
1. Rechargeable Battery is dead.
2. Battery is not charged
for over 4-3 months.
1. Recharged or replace battery
2. Recharged or replace battery
1. Recharged or replace battery
2. Replace battery.
1. Use shielded cable
1. Plug into AC outlet to recharge.
SIMPLE TROUBLE SHOOTING

Pyle PSBT125A Specifications

General

Brand	Pyle
Model	PSBT125A
Category	Speaker System
Language	English