Pyle PSS6 - Making the Connections; Cautions for Making Connections

www.PyleUSA.com 3
If you’re using non-terminated speaker wire, do not use any speaker wire that is
larger than 14 gauge. The lower the gauge number, the larger the cable (e.g., 12
gauge is larger in actual physical size than 14 gauge).
• Do not hook the outputs of one selector into the inputs of another speaker
selector together.
MAKING THE CONNECTIONS
The control center divides the power from your receiver/amplier dierently to
its speaker terminals. (This is especially noticeable when you connect only one
pair of speakers. If you connect more than one pair of speakers, see “Impedance
Chart” on page 5 to selector the best terminals to connect.)
For the best performance, make the connections based on how frequently you
use each set of speakers.
CAUTIONS:
To avoid damaging your speakers or receiver/amplier:
• Be sure your receiver/amplier’s power is turned off before you make the
connections.
• Never let the speaker wire’s bare ends touch each other or the adjacent terminals
on the control center.
• Do not connect more than one pair of sepakers to each set of terminals.