www.PyleUSA.com
10
Using Headphones
To listen privately, or to monitor sound sources, connect a pair of low impedance
stereo headphones (not supplied) with 6.35mm plug into the PHONES jack on the
amplier front panel.
Please listen safely. Follow these recommendations:
Do not listen at extremely high volume levels. Extended, high-volume listening
can lead to permanent hearing loss. Always start with the volume control set to a
LOW level BEFORE you put the headphones on. Then gradually increase the volume
as necessary.
Connecting to standard AC power
After making all other connections, set the POWER switch to OFF position. Then
connect the power cord to a standard AC outlet.
Connecting to 4A/12V DC power
You can power the amplier from your vehicle's 12-volt battery. Connect the supplied
DC power cable's barrel plug to DC 12V IN jack on the amplier, and then connect
the cable's other end to the 12-volt accessory socket on the vehicle, such as the
cigarette-lighter socket.
CAUTIONS:
PLEASE UNPLUG THE AC POWER CORD BEFORE CONNECTING THE DC POWER
CABLE FOR THIS 12V POWER USAGE, AND DISCONNECT THE DC POWER CABLE
BEFORE PLUGGING IN THE AC POWER CORD FOR AC POWER USAGE.
4 Ohm 10w
Speaker
+
-
0.62
1.25
2.5
5
10
com
(watts)
com
(ohms)
16
8
4
To Next Page
Loading...
Need help?
General
