1、AUTO
Automatically search the signal source when power on.
2、CD/DVD
CD/DVD Selector.
3、AUX
AUX Selector.
4、TUNER
TUNER Selector.
5、LOUD
Press the button to increase both bass treble.
6、IPOD/MP3
IPOD/MP3 Selector、
7、AUTO SCAN
AM/FM auto scan selector，scan and store stations
automatically. Can store 50 stations.
8、MEMORY
After a station has been found，you can store the station
by pressing the MEMORY button and the screen will
display SAVE.
9、ST/MONO
Stereo and mono selector.
10、AM/FM
AM/FM selector.
11/12、PREV< NEXT>
Stations preview and next selector.
13/14、TUNING< TUNING>
The two keys are used to adjust to the best signal of
the stations.
15、BASS
16、L/R
Left / Right Balance Control
17、TREBLE
18、VOL+ VOL-
Master Volume Up And Down
19、MUTE
Mute Selector
Remote Control Operation
1. Remote control should be operated within 6
meters and the scope of 30 in front of receiver.
2. Make sure that there is no big obstacle between
remote control and machine.
3. Remote sensor should be far away
from the light,high amounts of light can affect its performance.
5 2
1.Power source-The unit should be connected to a power supply AC~110V/60Hz,
AC~220V/50Hz.
2.Ventilation-The unit should be situated so that its location or position does not
interfere with its proper ventilation. Place the unit at least 10cm away from the
walls.
3.Water and moisture-The unit should not be used near water-for example, near a
swimming pool in a wet basement, etc.
4.Electric shock-if a metal object, such as hair pin or needle comes into contact inside
this unit, a dangerous electric shock may result. For families with children, never
permit children to put anything, especially metal, inside this unit.
5.Enclosure removal-Never remove the enclosure. If the internal parts are touched
accidentally, a serious electric shock might occur.
6.Abnormal smell-if an abnormal smell or smoke is detected, immediately turn the
power OFF and pull out the power cord. Contact your dealer or nearest service
station.
1. Make sure that all connections are properly connected and the main
volume is set to minimum level before turning on the unit.
2. When more than one pair of speakers are used, (specially the main
speaker output) make sure that the speakers used are of the same
wattage and impedance, otherwise the unit maybe damaged under
high power or long term operation.
3. To avoid humming sounds and unwanted noise, make sure that all the
wires are properly inserted.
4. For speaker cords, strip off the vinyl coating and twist the wire tip.
Push down the pink jack or loosen the screw terminal, before inserting
the wire tip, then fasten it and tighten the screw. Be careful not to let
the wires stick out of the terminal otherwise this may cause a short
circuit when wires of different terminal contact each other.
5. After the unit is turned on, adjust the main volume to the desired level
same is true with the bass and treble volume, etc.
SAFETY INSTRUCTIONS
Precautions
Remote Safety Instructions and Precautions
LOUDCD/DVD
AUX
AUTO SCAN
MEMORY
ST/MONO
AM
PREV
TUNING TUNING
FM
NEXT
BASS TREBLE
++
--
IPOD/MP3TUNER
AUTO
L R
VOL+
VOL-
AMPLI FIER REMOT E
1
2
3
4
7
8
9
15
16
5
6
10
11
12
13
14
17
18
16
19
18
To Next Page
Loading...
Need help?
General
