Pyle PTAU23 - Connection Diagram and Care; Amplifier Connection Diagram; Care and Maintenance Guidelines

www.PyleUSA.com
6
www.PyleUSA.com
7
19. 110/220 Voltage Selector: This amplier has selectable input voltage from
110V/60Hz (the standard in USA and CANADA) to 220V/50Hz (for EUROPEAN
operation). Please make sure the switch is in the proper position before
operating, otherwise, the severe damage will be incurred and not covered
by the warranty.
20. 1/4" MIC Input Jack: Lets you connect a microphone with a 1/4" plug.
21. Switchable MIC PAGER and MIXING Modes: Set to PAGER, the signal from
AUX 1/AUX 2/CD will be attenuated BY -12dB and the signal from MIC will
override to page (Auto Talkover), it is good for paging system. Set to MIXING,
the signals from AUX 1/AUX 2/CD and MIC will be existed at the same time,
it acts like playing at KARAOKE event.
22. Replaceable Power Fuse: The amplier uses a fuse for protection against
surges and short circuit. If the amplier suddenly turns o and will not turn
on, check the fuse and if necessary replace it with a 1 amp, 250-volt, fast-
acting, 5x20mm fuse (not supplied).
23. AC IN Power Cord
Care and Maintenance
Your Pyle Pro Amplier is an example of superior design and craftsmanship.
The following suggestions will help you care for your amplier so you can
enjoy years of use:
• Keep the amplier dry. If it gets wet, wipe immediately.
• Use the amplier only in well-ventilated installations.
• Handle the amplier gently and carefully - do not drop!
• Keep the amplier away from dust adn dirt.
• Wipe occasionally with a damp cloth to keep it looking new.
• Do not use harsh chemicals, solvents or detergents!
CONNECTION DIAGRAM