SET AUDIO INPUT & LINE OUT
AUDIO LINE INPUT OPERATION
If you would like to use the audio line-input function, to play audio from a connected device, please
turn the function switch to the position of “CD” MODE (This acts as the INPUT MODE).
Adjust the VOLUME control to obtain the desired sound level from the Speaker.
1．Set Audio INPUT Connecter:
2．Set Audio OUTPUT Connector:
*Please Note:
Before connecting your unit to any external devices / speaker systems, please turn off the power.
Turn on the AC power again after connecting.
Be sure the connecter is fitted and right into the connector jacks, or you may experience faulty
operation / static / interference / noise.
Make sure there is adequate 'slack' in any RCA connection or power cables.
Visit www.PyleAudio.com for additional product information and support
PyleAudio.com
To Previous Page
Loading...
