Need help?Do you have a question about the Pylex 12075 and is the answer not in the manual?
Lists and visually identifies all parts (A, B, C, D, E, F, #8, #10) included in the gazebo roof bracket kit.
Directs users to the appropriate installation guide based on gazebo dimensions (10'x10'/10'x12' vs. 10'x14'+).
Attaching part 'A' to the top of the four corner posts to establish the base structure.
Fixing beams to the 'A' part from below to create the top framing of the gazebo.
Positioning and installing 16 'C' brackets at specific locations on the gazebo frame.
Finding the gazebo center and measuring the height for the temporary support post.
Fixing two 'D' parts onto the temporary post as illustrated to support roof beams.
Securing 2x4s to 'C' and 'D' parts in the center of the beams.
Finishing the installation of 2x4 roof rafters to 'C' and 'D' parts.
Fixing four 'E' parts at 38 inches from the bottom of the roof frame.
Cutting each end of the 2x4 roof members at 9 inches from the structure.
Installing the 2x4 roof members around the entire structure.
Fixing 1/2" plywood onto the gazebo structure, with screw recommendations.
Attaching 'A' parts to the tops of the four corner posts for larger gazebos.
Fixing 'B' parts to the top of the middle posts for structural support.
Visual guide showing suggested methods for assembling corners with beams.
Attaching 'A' and 'B' parts to the 2x6 gazebo frame from below.
Installing 20 'C' parts at specified locations for a 10'x14' gazebo.
Measuring temporary posts at 60" on each side for larger gazebos.
Fixing 'D' parts onto each temporary post as illustrated.
Using provided screws to fix 2x4 roof members onto 'C' and 'D' parts.
Horizontally measuring and placing 2x4 roof members onto 'D' parts.
Fixing four 'E' parts at 38 inches from the bottom of the frame.
Fixing part 'F' in the middle of the roof structure as shown.
Cutting each end of the 2x4 roof members at 9 inches from the structure.
Installing the 2x4 roof members all around the structure.
Fixing 1½" plywood on the structure, with screw recommendations.
Replacing a part and tightening the central screw after plywood installation.
Installing 2x4 roof members for additional reinforcement.
General| Brand | Pylex |
|---|---|
| Model | 12075 |
| Category | Outdoor Furnishing |
| Language | English |
To Next Page