USING MASTER CONTROL SYSTEMS OTHER THAN PYRAMID
Connect power and signal leads per Figure 4.
Mount clock on wall using mounting holes located on back of clock. If clock is hardwired, attach security
mounting bracket to single or double electrical work box, then attach clock to bracket using four hooks.
The 41347G clock will synchronize on BCD correction or 58
th
or 59
th
minute of the hour depending on setting
of Master Clock Control System.
INSTALLATION
120VAC Correction
Red
24 VDC Correction
Blue
Ground
Green
Black
Neutral
Black
120VAC Power
Correction
Common
Grey
FIG4
If you have any questions,
please contact technical support at 888.479.7264 x1 during
regular business hours
Monday – Friday
8:00am-6:00pm EST
or email us @ custsvc@pti.cc
TECHNICAL SUPPORT
I2048E
Pyramid Time Systems, LLC
45 Gracey Avenue Meriden CT 06450
888.479.7264 203.238.0550 203.634.1696 fax
customerservice@pti.cc
email
pyramidtimesystems.com
WARRANTY
The manufacturer warrants this equipment to the original user against defective material or workmanship for a period
of 1 year from the date of purchase.
The manufacturer’s responsibility under this Warranty is limited to the repair or replacement of the defective part or
parts. Pyramid Time Systems reserves the right to determine whether the parts failed due to defective material,
workmanship, or other causes. Failure caused by accident, alteration, misuse or improper packaging of returned unit
is not covered by this Warranty. Users in countries other than the USA should contact the Dealer from whom the unit
was purchased. The rights under this Warranty are limited to the original user and may not be transferred to
subsequent owners.
To Previous Page
Loading...
