18
DISPLAY FAULT ACTION
F0
Touch control
software error.
If error has occurred disconnected and
connect again the cooktop to the power
supply. If error persist, call after-sales ser-
vice. If error appears suddenly in a normal
operation, call after-sales service.
Fc
Touch control zone
is too hot and has
turned o all the
heaters.
Wait until temperature goes down. Cook-
top will automatically recovered when
temperature reaches a normal value.
Ft / FE
Touch control tem-
perature sensor can
be damaged.
Wait until temperature goes down. If mes-
sage persist when temperature reaches an
environment value, call after-sales service.
Fb
Touch control tem-
perature sensor can
be damaged.
See if cook-top is mounted correctly. Be
sure that keys touch correctly the glass
surface.
FU / FJ
Excessive sensitivity
on any key.
This error is a keyboard auto-check. It
disappears when auto check return to
secure value. If error persist, call after-sales
service.
FA / FC / Fd
Security keyboard
error.
This error is a software auto-check. It dis-
appears when auto-check return to secure
value. If error persist, call after-sale service.
Fr
Relays security error Any relay driver can have any problemn.
Remove cook-top from the power supply,
wait a minute and switch on again. If error
persist, call after-sale service.
TROUBLESHOOTING
To Next Page
Loading...