6
Connecting via WPS
Locating the Camera’s WPS Button
Dome Camera PT-DOME Camera
Cube Camera
Pairing it with your Router
1. Power up the camera, after approximately 45 seconds you
will hear the camera make a “click” sound as it comes on-
line.
2. Locate the WPS button on your router and press for a few
seconds to activate the WPS set-up mode (as per the
router’s manufacturer instructions). Usually this will cause
an indicator light to activate.
3. Press and hold the WPS button on the camera for 3-5
seconds, then release the button.
4. You may see an indicator on the router to confirm that the
connection has been made but this depends on the router.
To Next Page
Loading...