V2 GSM Installation Manual
Pyronix Ltd Page: 20
5.17 ENABLE CLIP FOR TEL# [300]
CLIP is used in conjunction with the output type ‘CLIP Pulse’ (function 660) to activate
remotely outputs without having to wait for the V2 GSM to take the phone line.
For example:
If telephone number#1 is enabled for CLIP. and if an output#1 is programmed as ‘CLIP
pulse’, then when that telephone number is recognised by dialling in and hanging up after
one ring, the output#1 will pulse without the V2 GSM taking the phone line.
Press the [ or ] keys to scroll to
‘ENABLE CLIP for TEL#’ or enter
‘300’.
Press B or T to choose the
telephone number enter the function
shortcut number (see below). Press
t
Press B or T to choose between
Yes or No or select the number:
0 = No = Default
1 = Yes
Press t
Shortcut function numbers:
301: Enables CLIP inputs for tel #1 306: Enables CLIP inputs for tel #6
302: Enables CLIP inputs for tel #2 307: Enables CLIP inputs for tel #7
303: Enables CLIP inputs for tel #3 308: Enables CLIP inputs for tel #8
304: Enables CLIP inputs for tel #4 309: Enables CLIP inputs for tel #9
305: Enables CLIP inputs for tel #5
5.18 AUTO LEARN INPUT STATUS 1-6 [350]
The V2 GSM system incorporates the facility to automatically learn the normal (not alarm)
status the on-board inputs (the V2 GSM onboard inputs only, function not available the
RIX inputs).
Press the [ or ] keys to scroll to
‘AUTO LEARN INPUT STATUS 1-6’
or enter ‘350’.
The display will show the status of
each input on the keypad (6 inputs)
Press t
To Next Page
Loading...