Battery Information
The 1-way remote controls are powered by a single coin cell battery
(CR-2016), and the 2-way remote controls are powered by two coin
cell batteries (CR-2016) that can be purchased at most retailers. Oper-
ating range diminishes as battery charge depletes.
Low Battery Alert
When unlocking the vehicle using a remote control with a low battery
charge, the system provides a notification by emitting a third horn honk
output (if connected). If confirmation chirps are programmed off, the
system still emits one horn honk when unlocking. After performing a
command with the remote control, several beeps play to indicate the
battery/batteries need replacing. Once the alerts begin, the remote
control will remain operational for several days but the battery/batter-
ies should be replaced at the earliest opportunity or failure to control
the system may occur.
Battery Replacement
1. Unscrew the hardware on unit rear and remove from housing.
2. Use a small flat blade screwdriver and insert it into the slot located
along the bottom of the remote, near the key ring. Carefully pry
open the case.
3. Gently slide out the used battery/batteries to remove it from the
holding clip. Orient the new battery for the correct polarity and
insert into holding clip.
4. Realign the case parts and snap together by pressing firmly and
evenly on the front and back. Reinstall screw.
To Next Page
Loading...
Need help?
General
