8
© 1996 Directed Electronics, Inc.
Valet
®
Mode
You can prevent your system from automatically arming and triggering by
using Valet
®
Mode. This is very useful when washing the vehicle or having it
serviced. In Valet
®
Mode, the system will not arm, even with the transmitter,
but all convenience functions (door locks, trunk release, etc.) will work
normally.
To enter or exit Valet
®
Mode with the Valet
®
switch:
Turn ignition to "run" position, then turn to "off" posi-
tion. Press and release the Valet
®
switch within 10 sec-
onds. The Status LED will light steady if you have
entered Valet
®
Mode, and it will go out if you exited
Valet
®
Mode.
Using Remote Valet
®
as you enter or exit the vehicle:
Open any door. Press Button I (or the arm/disarm button). Press Button II (or
the channel 2 button). Press Button I again. The Status LED will light steady
if you have entered Valet
®
Mode, and it will go out if you exited Valet
®
Mode.
Nuisance Prevention Circuitry
TM
Your system has DEI's Nuisance Prevention Circuitry
™
(NPC
™
). It prevents
annoying repetitive trigger sequences due to faulty door pin switches or en-
vironmental conditions such as thunder, jackhammers, airport noise, etc.
Here's how it works:
Let's say the alarm triggers
three times
. Each time, the same sensor or switch
is triggering the alarm.The three triggers are within 60 minutes of each other.
NPC
™
will interpret this pattern of triggers as false alarms. After the third trig-
ger, NPC
™
ignores, or bypasses, that sensor or switch (along with any other
sensors or switches sharing the same zone). If the bypassed sensor tries to
To Next Page
Loading...
Need help?
General
