Introduction
The Q Acoustics Concept Series is a range of loudspeakers designed to meet the
highest expectations of dedicated 2-channel audiophiles and discerning movie
enthusiasts.
The range comprises:
Concept 20: Bookshelf speaker with a 125mm bass driver.
Concept 40: Floorstander with two 125mm bass drivers.
Before making any connections to your loudspeakers make sure that all active
units in your system are switched o at the mains.
When switching on your sound system or changing input sources, set the main
volume control at a low level. Turn up the level gradually.
NEVER play your sound system at full volume. The position of the volume control
is deceptive and does not indicate the power level of the system. Using very high
volume settings may damage your hearing.
DO NOT connect your loudspeaker terminals to the mains supply.
Q Acoustics Concept Series
DO NOT expose your loudspeakers to excessive cold, heat, humidity or sunlight.
If you play your loudspeakers without their grilles on, be careful to protect the
drive units from damage.
DO NOT use makeshift stands. Fit the Q-Acoustics dedicated stand according
to the instructions and using any xings provided. Your dealer will advise you.
DO NOT dismantle the loudspeaker. You will invalidate the warranty.
Unpacking your loudspeakers
Unpack the speakers fully. Lift the speakers from the cartons by holding the
cabinets. Do not use the protective bags to lift them. The Concept 40s are heavy
- get assistance to lift them if necessary.
When manoeuvring loudspeakers, do not drag them across the oor as this may
cause damage - lift them before moving them.
In the carton you will nd: The loudspeaker/s and this product manual.
Check the product carefully. If any items are damaged or missing, report this to
your dealer as soon as possible.
Retain the packaging for future transport. If you dispose of the packaging, please
do so following all recycling regulations in your area.
To Next Page
Loading...
Need help?
General
