www.aristospray.com
17
If the replacement of the power supply
cord is necessary, this has to be done
by the manufacturer or their agent in
order to avoid a safety hazard.
WARNING: All repairs must be
entrusted to an authorized service
center. Incorrectly performed repairs
could lead to injury or death.
Electrical supply- must match voltage
on machine nameplate
Extension cord-check continuity
Power supply cable-check continuity
Carbon brushes
Bad switch
Motor damage
Use correct outlet
Replace extension
Replace cable
Replace brushes
Replace switch
Replace or repair motor
Check
Problem: Motor will not run
Solution
TROUBLESHOOTING
Low paint
Clogged inlet strainer
Loose suction pipe
Intake ball not seating
Refill
Clean
Tighten connection
Clean or replace
Check
Problem: Pump loses prime or will not prime
Solution
Paint hardened in pump
Paint frozen in pump
Replace packings
Thaw pump
Check
Problem: Motor cannot turn pump
Solution
Clogged tip or filter
Relieve pressure and clean
Check
Problem: Pressure problems
Solution
To Next Page
Loading...
