11
5. Connecting QardioBase X to your Wi-Fi network
allows your weight data to be transmitted without
the need for your phone/tablet. If you would like to
connect QardioBase X to your Wi-Fi network, follow
the instructions on the screen of your phone or
tablet. To connect QardioBase X to your Wi-Fi
network you will need to know the following
information:
• Wireless network name (SSID).
• WPA / WPA2 password
(Due to security reasons, only networks with
WPA/WPA2 passwords are eligible).
• If you do not have this information, or you don’t
know how to change your WEP password or
open network to a WPA/WPA2 password
protected network, you can refer to the
manufacturer of your wireless router or contact
your Internet service provider for assistance.
6. Modes available:
• Normal
• Weight Only
• Pregnancy Mode
• Athlete Mode
See “Activating Special Modes” chapter for more
information
7. After setup is complete, step onto the scale to turn
on the scale, then step off to the scale calibrate. Wait
until you see the scale displays “00”, then step on the
scale again to measure. By default, your weight will
display rst followed by % body fat.
The Qardio App will show detailed body composition
data including, Weight, BMI, body fat %, muscle, bone
%, water %, Metabolic Age, BMR (Basal metabolic rate),
Subcutaneous Fat %, Visceral Fat %, Skeletal Muscle %,
Muscle Mass, Bone Mass, Protein %, Fat-free Body
Weight.
To Next Page
Loading...
Need help?
General