8. How to use
- One pull chain switch is for light control, another one for speed control
- The speed can be selected by pressing the speed chain
HI-1 pull, MED –2 pull, LOW—3 pull, OFF----4 pull
- Light on off can be controlled by pressing the light chain
ON–1 pull, OFF–2 pull
- Direction switch on the fan ‘s switch box(SUMMER and WINTER switch)
- Left for summer make the air movement directly from ceiling
- Right for winter, to circulate the warm air generated by heater to floor
9. Remote Control (remote control adaptable, but this model does not
included)
This ceiling fan can be installed with remote control, but make sure you know how to install the device
in safe way or
consult licensed electrician
Warranty may be affected if you install the improper remote control or install it in improper way
10.Disconnect from mains before maintenance or cleaning.
Do not use a wet sponge to clean the appliance.
1. Before conducting any cleaning or maintenance work, disconnect the lamp from the electrical supply
and wait until it
cools down
2. No abrasive products, solvents, detergent or any other liquid may be used to clean the fan or lamp
3. Be sure the power is off when you clean the fan
4. Don’t clean the motor, switch house and other electric parts of the fan with water in order to avoid
short circuit
To Next Page
Loading...
