5
How to Connect
First time Connection:
1. Pick up both earbuds, pop both earbuds into the case to activate them.
2. Pick up both earbuds again.
3. On cellphone search for QCY-T1C and tap to connect.
*Pick them up and the will auto power on, otherwise please charge and try again.
Switch Connected Device:
1. Turn off phoneA´s Bluetooth faculty and earbuds will auto disconnect and turn
connectable.
2. On phoneB, search for QCY-T1C and tap to connect.
*Multi-point connection is noc available. Earbuds will auto reconnect to phoneB upon
powering up again.
Factory Setting
Delete Connectivity Records:
(Please try the following steps if earbuds fail to connect)
1. On cellphone, delete the connectivity records of QCY-T1C.
2. Earbuds are power-off and out of case, hold MFBs for 10s or until LEDs blink red
and blue 3 times to power on and set factory.
*After factory setting, please refer first Time Connection to build connection with
cellphone.
To Next Page
Loading...
