Operating Introduction
Clearing the code :
Push the learning button on the receivers for 8 times , the codes will be cleaned .
After clearning the code, all the remote control cannot work any more.
Learning the code :(momentary)
Push the learning key on the receiver once time , it comes into momentary setting mode .
Wait for a moment , the LED will be off , it comes into learning state .
Push the remote button , LED indicator on the receiver board will ash then come off .
After 3 seconds, the LED indicator will be on again , learning successfully .
Learning the code : ( Toggle )
Push the learning key on the receiver twice time , it comes into toggle setting mode
Wait for a moment , the LED will be off , it comes into learning state .
QIACHIP RX480E-4 receiver module Instructions manual | 433.92MHz... https://qiachip.com/en-de/blogs/usermenu/qiachip-433-92mhz1527-lear...
2 von 16 25.02.2023, 11:43
To Next Page
Loading...
