Sensor
Broken Filament Detection
Automatic Leveling
Resonance Compensation
Voltage
Power Supply
Rated Power
Display Screen
Storage
Motion Controller
Electronics
WIFI
Software
Application Processor
Extruder
Independent Processor
Wifi Frequency Bands
Transmitter Power (EIRP)
Protocol
Slicer
Operating System
Support
Support
Support
100-240 VAC, 50/60Hz
800W
5.0 Inch 800*480 Touch Screen
8G EMMC and USB2.O Flash Drive
Dual-Core Cortex-M4
Quad-Core 1.5GHz Cortex-A53
Dual-Core Cortex-MO+
2.4 GHz
18 dBm (MAX)
IEEE 802.11b/g/n
QIDI Slicer and other third-party software, such as
Ultimaker Cura, Simplify3D, PrusaSlicer,etc.
Linux
Note: Since the first layer is more affected by the temperature of the hot bed, the chamber heater
starts working on the second layer by default.
To Next Page
Loading...
