8
EN
2. TECHNICAL SPECIFICATIONS
Rated voltage: 100-240 V~, 50-60 Hz
Power consumption: 50 W
Max. temperature: 230 °C
Protection class: Class II
3. PRODUCT DESCRIPTION
1. On/O switch with On indicator light
2. Clamp lever
3. Clamp
4. Heating barrel
5. Cool tip
4. OPERATION
1. Only use the curling iron on clean, healthy, dry and untangled hair.
2. Rest the curling iron on a smooth, sturdy, at and heat-resistant surface. Make sure that the
curling iron is well supported on its safety stands.
3. Connect the power plug to a suitable electrical outlet.
4. Slide the On/O switch (1) up to turn the device on. The indicator light with light up. Allow the
device to warm up for a few minutes before using it.
5. It is recommendable to wear a heat-resistant glove on the hand that you will use to wrap your
hair around the curling iron to protect your ngers from the heat emitted by the device.
6. Comb your hair thoroughly to make sure there are no tangles (Fig. C) and take a strand of
about 3-4 cm wide. Take a thicker strand to create loose curls, or a thinner strand to create
tighter curls.
7. Hold the strand straight, press the lever (2) to open the clamp (3) (Fig. A) and place the ends
of your hair around the barrel (4).
8. Release the lever (2) to close the clamp (3), making sure that the ends of your hair protrude
slightly from the clamp (Fig. D).
9. Hold the curling iron by the handle with one hand and the cool tip (5) with the other, and start
to wrap the strand of hair around the curler (Fig. E). Wrap the strand on the curler up to the
desired height of the curls.
10. Hold in place for 5 to 8 seconds, depending on your hair texture and length (Fig. F). Reduce
the time if your hair is short, or if you want to create bouncy curls or soft waves.
11. To release your hair, unwrap the strand and press the lever (2) to open the clamp (3). Allow
your hair to cool completely to set the curls. You can gently comb or run your ngers through
the curls to loosen them up.
12. Repeat the procedure on the other sections of your hair.
13. Once you have nished using the device, slide the On/O switch (1) down to turn the device
o and unplug the device from the electrical outlet.
14. Allow the device to cool down completely before storing.
To Next Page
Loading...
Need help?
General