7
EN
3. PRODUCT DESCRIPTION
1. Power button & indicator light
2. Coffee button & indicator light
3. Steam button & indicator light
4. Top cover
5. Steam control knob
6. Main body
7. Swivel steam wand
8. Drip tray
9. Drip tray grid
10. Portafilter handle
11. Filter holder clip
12. 2-Cup filter basket
13. Portafilter
14. Measuring scoop/tamper
15. Handle
16. Tank lid
17. Removable water tank
4. USE
4.1. BEFORE FIRST USE
Before first use, wash the water tank, portafilter, drip tray and grid, measuring scoop and filters in
warm, soapy water. Rinse and dry thoroughly. Do not immerse the appliance, power cord or plug
in water or any other liquid.
To ensure the first cup of coffee tastes excellent, you should prime the coffee maker as follows:
1. Add water into the water tank, the water level should not exceed the “MAX” mark in the tank.
Then replace the tank cover.
Note: the appliance is supplied with a detachable tank for easy cleaning. You can fill the
tank with water first, and then replace the tank in the machine.
2. Insert the filter into the portafilter (do not put coffee in the filter). Be sure to align the edge
notch on the filter and portafilter to insert (or remove) the filter, then rotate the filter a little so
it won’t come out of the portafilter.
3. Install the portafilter into the appliance from the “unlock” position (the 3 tabs on the
portafilter must align with the notches in the group head), then turn it counterclockwise until it
locks into the “lock” position .
4. Place a large container on the drip tray. Make sure the steam control
knob is in the OFF position (the triangle mark on the knob points to “O”).
5. Connect the appliance to power supply. Press the On/Off button once,
the power indicator will flash blue.
6. Press the Coffee button , the pump will start to pump water. When
there is water flowing out, close the pump by pressing the Coffee button.
Press the Coffee button, hot water will flow out.
7. After water does not drop out any more, discard the water in the
container and clean it thoroughly. Now you can start brewing.
OFF
Notes:
• There may be noise when pumping water for the first time, this is normal, the appliance is
releasing the air inside. The noise will disappear after about 20s.
• The coffee button indicator may show a warning when the appliance is first used, this is
normal, just press the Coffee button. The warning will disappear after about 20s.
4.2. PREHEATING
To make a good cup of espresso, we recommend that you preheat the appliance before brewing,
including the portafilter, filter and cup, so that the coffee flavour is not affected by the cold parts.
1. Remove the detachable tank and open the tank cover to fill it with the desired amount of
water, the water level should not exceed the “MAX” mark on the tank. Then place the tank
into the appliance properly.
2. Insert the filter (no coffee grounds) into the portafilter.
3. Install the portafilter into the appliance from the “unlock” position (the 3 tabs on the
portafilter must align with the notches in the group head), then turn it counterclockwise until it
locks into the “lock” position .
To Next Page
