12
EN
6.1.2. REPLACING THE DUST BAG
Empty or replace the dust bag when the “Dust bag full” indicator (3) turns red, or when it
is half-full but there is a loss in suction power.
11
1. Turn o and unplug the vacuum cleaner.
2. Press the Front cover release button (7) to open the
cover.
3. Hold the collar of the dust bag and gently slide it upwards
to remove it from the holding frame (Fig. 11).
12
4. Gently slide a new dust bag into the holding frame and
close the front cover. Do not unfold the new dust bag.
Keep it in its original folded state for easy installation and
closing of the cover (Fig. 12).
6.2. MOTOR FILTER
The motor lter should be replaced after every 5 dust bags. In between, the lter can be
cleaned.
13
Cleaning or replacing the motor lter
1. Cleaning or replacing the motor lter
2. Turn o and unplug the vacuum cleaner.
3. To access the motor lter, press the Front cover release
button (7) to open the cover.
4. Remove the dust bag.
5. Slide the lter holder (24) upwards to remove it (Fig. 13).
a) Detach the motor lter (23) from the lter holder (24)
and rinse them under the tap with lukewarm water
(Fig. 16). Allow to air dry for 24 hours (Fig. 17) before
inserting them back into the vacuum cleaner.
b) Or, remove the motor lter (23) from the lter holder
(24) and discard it. Attach a new motor lter to the
lter holder (24), and insert them back into the vacuum
cleaner.
To Next Page
Loading...
Need help?
General
