Qilive Q.6594 - TROUBLESHOOTING DRYING PROBLEMS; Dishes Not Drying Properly; GUARANTEES AND LIABILITY LIMITATIONS; Guarantee Period and Covered Exclusions

35
EN
Problems
Possible
causes
What to do
The dishes
aren’t
drying.
Improper
loading.
Reload the dishes following the directions.
Dishes are
removed too
soon.
Do not empty your dishwasher immediately
after washing. Open the door slightly to allow
the steam to escape. Do not take the dishes
out until the inside temperature is safe to touch.
Unload the lower basket rst to prevent water
dripping down from the upper basket.
The wrong
program has
been selected.
With a short program, the washing temperature
is lower which decreases the cleaning
performance. Choose a program with a longer
washing time.
Use of cutlery
with a low-quality
coating.
Water drainage is more di󰀩cult with these
items. Cutlery or dishes of this type are not
suitable for washing in the dishwasher.
10. GUARANTEES AND LIMITATIONS OF
LIABILITY
This product is guaranteed for a period of 36 months (including the legal guarantee of
24 months as dened by local law as well as a commercial guarantee of 12 additional
months o󰀨ered by the brand) from the date of purchase, against any failure resulting
from a manufacturing or material defect.
This guarantee does not cover damage resulting from a faulty installation, incorrect
use, or normal wear and tear.More specically, the guarantee does not cover:
■ Damage or problems caused by incorrect use, accidents, modications or an
electrical connection with the wrong current or voltage.
■ Products that have been modied or whose tamper evident seal or serial number
has been damaged, altered, removed or rusted.
■ Replaceable batteries and accessories are guaranteed for 6 months.
■ Battery failure, as a result of over-charging or non-compliance with the safety
instructions set out in the manual
■ Cosmetic damage, including scratches, bumps and any other element.
■ Damage caused by any servicing operations carried out by non-authorised
persons.
■ Faults caused by normal wear and tear or the normal ageing of the product
■ Software updates as a consequence of changes to network settings
■ Product failure resulting from the use of third party software to modify, change or
adapt the product as supplied
■ Product failure resulting from its use without manufacturer-approved accessories
■ Rusted products