12
EN
5.2. CLEANING AND REPLACING THE FILTERS
5.2.1. INLET FILTER
The inlet lter is located behind the dust bag. Release the front cover lock (2) to open the front
cover (3) and remove the dust bag.
Take out the air inlet lter frame by pulling it upwards
(Fig 12).
Clean the inlet lter with warm water and allow to dry
thoroughly before placing back into the unit (Fig 13).
Fig. 12
Fig. 13
If the lter shows signs of wear and tear it must be replaced; Open the frame and remove
the lter from the frame. Replace with a new lter. Contact customer services for support.
5.2.2. CLEANING AND REPLACING THE OUTLET FILTER
To avoid the lter getting clogged, never use the vacuum cleaner without the lter.
The outlet lter is located under the air outlet cover (11). It cleans the exhaust air of the vacuum
cleaner.
Remove the air outlet cover (11) gently by pulling it from the
casing.
Remove the lter from the vacuum cleaner (Fig 14).
Carefully shake off foreign objects or use a soft brush for
initial cleaning.
Wash the lter carefully in clean water without using any
cleaning agents. Leave the lter to dry.
Reinsert the lter after it is completely dry (Fig 15).
Fig. 14
Fig. 15
To Next Page
Loading...
Need help?
General
