26
4
SPECIFICATIONS
Max.Wattage: 9,5 kW
Min. Wattage: 5 kW
Gas Consumption: 450 g/hr-675 g/hr
Height: 223 cm including stand
Weight: 25 kg
Model PGP113
Gas type propane, butane or LPG only
Countries of des-
tination (*)
BE, DK, FIN, FR, IT, NL,
NO, SE, SL, LUX
BE, ES, FR, GB, GR, IT, LUX,
PT, SL
Gas Category I3 B/P (30) I3+ (28-30/37)
Pressure (mBar) 30 28-30/37
(*) This appliance is not suitable for Germany, Austria, Swiss
ASSEMBLY
Required tools
• Open end wrench 10 & 13 mm
• Adjustable opening wrench (2) 20 cm (8’’) long
• Slip joint pliers 23 cm (9’’) long
• Philips screwdriver w/ medium blade
• PIumbing tape for joints
• Spray bottle of soap solution for leakage test
Parts supplied
• See pic. 3
Step 1: pic. 4
• Take the control box (2) and the plate cover (7) out of the middle plate (1) by
unscrew the screws (17).
Step 2: pic. 5
• Connect and fix the 4 lower supports (4) to bottom plate (3) and middle plate
(1) using the screws (17).
Step 3: pic. 6
• Connect the upper supports (5) to the lower supports (4) and fixed by screws
(17), then fix the upper plate (6) to 4 upper supports (5) using the screws (17).
Step 4: pic. 7
• Fix the plate cover (7) onto the middle plate (1) using the screws (17).
Step 5: pic. 8
• Install one AA batter (20) into the control box, then fix the control box (2)
underneath the middle plate (a1) using the screws (17).
Step 6: pic. 9
• Carefully put the glass tube (8) up through the center hole in the upper plate
(6). Make sure the rubber ring is attached on the lower end of the glass tube
(8). Move and place the glase tube (8) through the hole of the plate cover (7)
on the middle plate (1). Check and ensure that the glass tube (8) covers the
center hole of the middle plate (1).
To Next Page
Loading...
