27
Step 7: pic. 10
• Fix the reflector (10) onto the damper (9) using the screws (17).
Step 8: pic. 11
• Attach the protection guards (11) onto the frame by putting their hooks into
the holes of the frame. Fix the guards using the fixing brackets (14).
Step 9: pic. 12
• Fix the 3 side panels (15) using the screws (17).
Step 10: pic. 13
• Screw the handle (18) onto the fron panel (16), attach the connector (12)
back to the front panel, screw them with 2 M4x8 boltes, hook the chain (19)
to the hole in the control box, then close the panel to the middle panel. The
panel is attached using magnets.
Tips: The chain can hold the panel while operating the controls.
Step 11: pic. 14
• Complete!
OPERATION
• Connect the gas hose to the gas connector. (pic. 15)
Please note:
- The gas hose is NOT included with the heater. Hose must be purchased sepa-
rately
- Minimum / Maximum length gas hose: 60-80 cm
- Screw connection (France G1/2) is fitted as standard
- Hoses 8-13 mm. can be fitted as well. When required: use the multi country
connector (pic. 16) supplied. Fitting of the multi country connector is descri-
bed in the separate manual supplied in with the included multi country kit.
When using the multi country connector: ALWAYS make sure to use hose
clamps!
• For gas hose with threaded connectors: bind 2 or more rounds of plumbing
tape around the gas pipe before connecting the gas hose for security.
• Bind 2 or more rounds of Teflon plumbing tape around the gas burner inlet
connector and connect the gas pipe. Use a wrench to tighten the connection.
• Connect the other end of your gas hose according to the mounting instruc-
tion as supplied with the gas hose and/or supplied with the gas regulator.
Note:
- The gas hose is NOT included with the heater
- The gas regulator is not included with the heater
• Connect the regulator to the gas cylinder (not included) according to the
mounting instruction as supplied together with the gas regulator and/or the
gas cilinder
• Put gas cylinder on the base.
4
To Next Page
Loading...
Need help?
General
