28
4
LIGHTING INSTRUCTION
• Check and ensure that an AA battery is inside the ignition chamber. Use a
new battery so you are sure the battery is full of power.
• Battery is not included in the package.
• Ensure that the ‘+’ side of the battery is facing outside (so ‘+’ faces towards
the user)
TO TURN ON THE HEATER
Check that the regulator seal is correctly fitted and able to fulfil its function.
a) Open the valve on the gas supply cylinder.
b) See pic. 18 and table 1, Press and turn the variable control knob (5) to PILOT
position (counter-clockwise 90°).
c) Press down the variable control knob and hold for 30 seconds. While holding
down the variable control knob press the igniter button several times until
the pilot flame ignited. Release the variable control knob 10~20 seconds after
the ignition.
Note:
1. If a new tank has just been connected, please allow at least one minute or
more for the air in the gas pipeline to purge out through the pilot hole,
2. When lighting the pilot flame make sure that the variable control knob is
continuously depressed while pressing the igniter button. Variable control
knob can be released after the pilot flame lit for 10-20 seconds.
3. Pilot flame can be watched and checked from the peephole Iocated on the
base of burnerhead . If the pilot flame does not light or it goes out, repeat
step c.
d) Turn the variable controI knob to LO and Ieave it there for 5 minutes or more
before turning the knob to desired temperaturesetting.
e) If the burner flame goes out accidentally or it is blown out by wind, turn off
the heater and wait at Ieast 5 minutes or more to let the gas dissipate before
re-lighting to avoid possible gas explosion. Repeat steps b to d.
FR GB IT NL
Off Off Spenta Uit
Position
d'allumage
Ignite posi-
tion
Posizione di
accensione
Ontstekings
positie
Capacité fai-
ble
Low capacity Bassa capa-
cità
Laag vermo-
gen
Capacité éle-
vée
High capacity Alta capacità Hoog vermo-
gen
Table 1
TO TURN OFF THE HEATER
a) Turn the variable control knob to PILOT position.
b) Press and turn the variable control knob to OFF position.
c) Turn off the valve on the gas cylinder and disconnect the cylinder.
To Next Page
Loading...
Need help?
General
